News

Company News

Stoner RotoFlow™ Enhanced for Crosslinked Polyethylene

Oct 11, 2016, 14:11 PM
Stoner RotoFlow™ Enhanced for Crosslinked Polyethylene
Stoner Molding Solutions Enhances RotoFlow™ Mold Release for Better Performance


Quarryville, PA (October 2016) –
Stoner Molding Solutions, the world’s largest manufacturer of rotational mold releases, announces the re-development of RotoFlow™ a high-efficiency mold coating for rotomolded polyolefin and nylon resins.

Stoner RotoFlow™ was released in 2015 as a flow enhancer to increase detail in rotationally molded polyolefin and nylon parts. Now the NEW RotoFlow™ is available in a larger 13oz size with a new formula that is compatible with crosslinked polyethylene.

crosslinked-polyethylene-molded-with-original-rotoflowcrosslinked-polyethylene-molded-with-new-rotoflowCrosslinked polyethylene molded with Original RotoFlow™ and Crosslinked polyethylene molded with NEW RotoFlow

Inserts, tight radii, threads, and deep cavities are often hard-to-fill areas of rotationally molded parts. This common problem can result in weak or defective components of the molded part often leaving it unusable. Stoner RotoFlow™ increases the flow of polyolefin and nylon resins into these difficult areas producing a fully molded part and nearly eliminating voids, pinholes, bridging, thinning, and static lines on the surface.

Stoner RotoFlow™ users have reported higher part quality, increased production efficiency, and reduced operational waste allowing them to achieve higher production goals in less time using this product.

Stoner RotoFlow™ does not contain ozone depleting substances or chlorinated solvents.  Stoner RotoFlow™ is sprayed directly onto the internal mold surface and is suitable for use with most metal surfaces. Stoner RotoFlow™ is available at www.stonersolutions.com/trasys.

Benefits of Stoner RotoFlow™

  • Improves the quality and consistency of rotomolded polyolefin and nylon parts.
  • Removes pinholes, voids, and blow outs.
  • Improves the appearance and operational performance of threads.
  • Increases the strength of inserts.
  • Contains no Class I or Class II ozone depleting substances.
  • Contains no CFC or HCFC propellants or solvents.
  • Contains no chlorinated solvents such as 1,1,1 trichloroethane or methylene chloride.

Media Contact:
Peter Taraborelli
ptaraborelli@stonersolutions.com
Office: 717-806-6054


Shop Now

Unlike many mold release brands, Stoner Molding Solutions formulates, manufactures, and distributes our own products. Check out our full line of mold releases, sealers, cleaners, rust preventives, and lubricants. In stock products are ready to ship now!

Shop Now